What should be paid attention to in cable joint?

First of all, we have to choose the appropriate joint material according to the model and specification of the joint cable. Now the quality of the cable joint material is also uneven. However, in order to ensure the quality of the cable joint, it is recommended not to be greedy for cheap. It is best to choose the material of the cable joint manufacturer with reliable quality. Guangzhou Jiaxin Electric Appliance Co., Ltd. is a good choice!

First: it's best not to choose rainy days when making cable joints, because water ingress into the cable will seriously affect the service life of the cable, and even short circuit accidents will occur in serious cases!

Second: before making cable joints, you must carefully read the manufacturer's product instructions, which is particularly important for 10kV and above cables! Think about all the processes before you do it!

Third: for the terminal connector of single core armored cable above 10kV, remember that only one end of the steel strip can be grounded!

Fourth: the copper tube can not be pressed too hard, as long as it is crimped in place! The copper end face after crimping is bound to have many convex starting points. This must be flattened with a file without leaving any burrs!

Fifth: when using the blowtorch, the heat shrinkable cable connector should pay attention to the blowtorch moving back and forth, and can not continuously supply fire in only one direction!

Sixth: the size of the cold shrinkable cable joint must be made in strict accordance with the drawing instructions, especially when pulling out the support in the reserved pipe, be more careful!

This article is organized by cable joints. This article does not represent the viewpoint of this station